Shipping Your Lazy Boy Recliner

December 16th, 2008 in Adjustments & Repairs, Used Recliners /

If you are moving or shipping your lazy boy recliner, you will want to take the proper precautions so it is not damaged in the move. The reclining mechanism makes moving your recliner more complicated than simply moving a chair and you can cause serious damage if you are not careful.

First consider that your recliner weighs more than a stationary chair so you must be careful when lifting it. Always lift it from the sides of the bottom and not by the back and foot rest which could damage the reclining mechanism.

There are certain steps you can take to prepare your recliner for shipping or moving that will help reduce the risk of damage. First you might want to consider removing the handle if it might get caught or broken in shipping your recliner. You should find an allen head or torx head screw holding it to the shaft. You will have to loosen or remove this and perhaps give the handle a twist anti-clockwise to loosen it off. Be careful when twisting the handle particularly if it is a wooden one as they can sometimes crack or split.

You can also remove the back on several models of lazy boy recliners. You should be able to locate the back brackets on the outside of the back from for most recliner models. The Lazy Boy Classics Low Profile Recliner and the High Leg Recliner back brackets are located on the inside of the back frame. These brackets have a small locking lever that is pushed down to lock the back in place. On some models you will have to lift the upholstery material which could be held in place with fastening tape in order to locate the brackets.

Once you have located the back brackets and the locking levers, you will have to lift the locking lever about 45 to 60 degrees to unlock the back on both sides. You may need to use long nosed pliers to open the locking lever. Be sure to pull it carefully to avoid bending it. You should then be able to slide the back straight up to remove it from the recliner.

To replace the back first ensure that the locking lever is fully opened and slide the back straight down into the bracket ensuring that both sides are properly engaged. You can then use a screwdriver to push the locking lever back down into its locking position. Do not operate the unit until the back is properly installed and in the locked position.

4 Responses to “Shipping Your Lazy Boy Recliner”

  1. Don in Pedro Says: October 31st, 2009 at 10:40 am

    Amazing! I found the latches, removed the back and the rest was easy!Thanks for the hint!

  2. roaul Says: October 9th, 2011 at 7:40 am

    MY Lazy boy foot rest dumps out on the floor.. how do I fix is the couch model./..

  3. Ralph Nutter Says: February 14th, 2012 at 11:17 am

    My 2 yr old recliner will not recline. how can this be fixed?